Blending Silos

Achtung, öffnet in einem neuen Fenster. Druckbutton anzeigen?E-Mail

RUBERG-Blending Silos

RMS series: Blending system with multi-purpose possibilities ...

Sizes:

As a blending silo with a capacity from 100 litres to 20.000 litres or as a large-capacity blending silo with a capacity of up to 100 m3. In a position suitable for inside or outside assembly. Low operating costs thanks to low required power, low-maintenance and wear. Product-friendly homogenizing, drying, cooling and dyeing can for example be carried out in one working cycle.

rms_typ_6000rms_typ8000_15pro

 

 

Mixing
Homogenizing
Loosening
Storing
Heating
Cooling
Drying
Tempering
Ageing
Overflowing
Dyeing
Humidifying
Gasing

 

 

 

 

 

Working Method:

Depending on its characteristics the product to be blended is fed either on top or at the side. It is also possible to feed it directly into the blending screw which is in the lower part. The blending screw consists of a sturdy central tube with welded anger-type helixes. The conical diameter and the progressive ascending slope are the decisive characteristics of the blending tools. They are chosen according to the silo diameter. Thanks to the special geometry of the open, slow turning blending anger the product can slowly flow from all horizontal levels of the silo towards the centre, where it is fed upwards with a slowly increasing feeding speed.

Horizontal and vertical currents blend the whole silo contents perfectly within a short time. The RUBERG-Blending Silo is equipped with an insulated double casing, so thermal blending tasks can be carried out.

Diagram of a RUBERG granulate blending and drying plant with RUBERG Blending Silos

rms diagramm1-en